A detailed overview of the WQD 10-10 1.1 pump
The pump model WQD 10-10 1.1 is manufactured in Poland. The pump weighs about 13 kg. The body is cast iron. The device is designed for submersion to a depth of 10 m. The maximum height of water rise is 10 m. Engine power is 1.1 kW. The pump operates from a single-phase network with a voltage of 220V and a frequency of 50 Hz. The maximum pumping volume of water is 165 l / min. The diameter of the hole for connecting the hose is 4 cm. The number of revolutions is 2850 rpm. Pump capacity - 10 m3/hour.
The pump has a 2-year manufacturer's warranty.
Device and equipment
The pump is equipped with a cast iron impeller. The drive shaft is made of stainless steel AEC-316 standard. The pump is equipped with a ceramic-graphite mechanical seal with an outer diameter of 50 cm and an oil seal, which is attached to the pump by means of a coupling. This seal extends the life of the pump.
After pumping out, 90 mm of water remains, since the pump intake holes are located at a height of 10 cm from the bottom of the housing. The set includes a spare 10 m cable and a float that turns off the pump motor in case of insufficient water level. Also, the pump is equipped with an automatic shutdown system in case of overheating. Winding insulation class F.
Operating conditions
The pump is designed for drainage and pumping water from the sewer and wells... It can pump water contaminated with large particles. The maximum particle diameter is 4 cm.
It can be used to fill tanks with water. The pump is perfect for supplying water to the pool.
The pump also works well in wetlands, as it is protected from sticky dirt on the impeller. Small stones can get inside the pump. In this case, the pump impeller will stop.
The pump runs fairly quietly. The motor makes a whirring sound if the pump is completely submerged in water. When a stone enters the pump working element, the protection is triggered and the motor stops.
This pump can pump water, the temperature of which is from 0ABOUTFrom to 35ABOUTFROM.
Important! The hose is fastened with a metal clamp to the outlet. Rigid hoses (plastic or reinforced) are connected to the WQD 10-10 1.1 pump. A fire hose or silicone hose will not work, as it will bend and the pressure will be greatly reduced.